Caterpillar D6N XL Bulldozer (Stock No. 95513) CAT D6 Dozer

- 9619 Hours (currently working may increase)
- VPAT Blade, A/C ROPS Cabin, Rippers, Rear Bash Guard, Heavy Duty Side Tank Guards, Dual Slope Boards (removed but can be re-fitted), TopCon GPS Ready

Work done so far to machine (approx 1150 hours ago)
- 1000 hour service completed
- All new CAT filters
- New sump drain valve
- New transmission drain plug
- Removed old blade slope boards
- 3 x new ripper boots fitted
- Fitted new cutting edges
- All new bottom track frame wear strips
- All new front and rear angle cylinder blade bearings x 4
- All new lift cylinder blade bearings x 4
- All new tilt cylinder blade bearings x 2
- New c-frame pins and bearings
- Re-sealed pivot shaft seals (both sides)
- New track adjuster cannon seals and bearings (both sides)
- Rebuilt equalizer bar (new pins/bearings/seals)
- Linebored c-frame main pivot pin bores
- Linebored c-frame lift cylinder rod end bores
- New equalizer bar centre pin bushings in machine main frame
- Linebored both track frame equalizer bar side pin bores
- 8 x new track chain master bolts
- New c-frame plugs and spacer rings
- All new bottom blade dogbone bearings x 2
- New blade angle cylinder barrel end pins x 2
- All new blade dogbone spacers x 4
- Re-sealed LHS blade angle cylinder
- Re-sealed RHS blade angle cylinder
- Re-sealed LHS blade lift cylinder
- Checked all other blade cylinder seals
- A/C re-gassed and tested
- Completed paint touch ups
- Cleaned and detailed inside cab
- Repainted part of cabin floor interior
- New front and rear genuine CAT floormats inside cab
- New ripper cylinder retaining bolts
- 1 x new engine door latch
- Some new spiral wrap on blade
- New interior side carpet inside cab
- One new pivot shaft o-ring
- New hydraulic compensator fitted by CAT. Adjusted into spec
- Capped off old aftermarket control valve for old slope boards
- Fitted new roof plate to sweeps
- Fitted new side and rear screens
- Installed new decal kit
- Repaired crack in muffler box
- 1 x new hose under machine
- New blade joystick handle
- Fitted new stick rake and tree pusher
- Re-skinned blade
- Fitted new alternator

Wholesale Price ---- $235,000+GST including all of the above (Stick Rake and Tree Pusher available at additional cost)

Due to staff shortages, inspections are by prior arrangement only